How does the scanning mode of the LED display come about?

Jun 13, 2024

Leave a message

How does the scanning mode of the LED display come about?

 

 

HD led video wall

In the LED display, the ratio of the number of rows lit at the same time to the number of rows in the whole area is called the scanning method. The scanning is also divided into 1/2 scan, 1/4 scan, 1/8 scan, 1/16 scan and other driving modes. That is to say, the driving mode of the display is different, so the setting of the receiving card is also different. If the receiving card was originally used on a 1/4 scan screen and is now used on a static screen, the display on the display will be every 4 lines and one line. Generally, the receiving card can be set, and the main devices such as the sending card, the display screen, and the computer can be connected to the relevant software on the computer for setting. Next, let's take a look at the scanning method and working principle of the LED display.

 

1. LED electronic display scanning method:


1. Dynamic scanning: dynamic scanning is the implementation of "point-to-column" control between the output of the driver IC and the pixels, and the dynamic scanning requires a control circuit, and the cost is lower than that of static scanning, but the display effect is poor, and the brightness loss is large.


2. Static scanning: Static scanning is the implementation of "point-to-point" control between the output of the driver IC and the pixels, and the static scanning does not require a control circuit, and the cost is higher than that of dynamic scanning, but the display effect is good, the stability is good, and the brightness loss is small.

 

2.The working principle of the 1/4 scanning mode of the LED electronic display:


It is the time for each line of power supply V1-V4 to be turned on 1/4 of the time according to the control requirements in one frame of image. The advantage of this is that the display characteristics of the LEDs can be used more efficiently and the hardware cost can be reduced. The disadvantage is that each line of LEDs can only display 1/4 of the time in a single frame of the image.

 

Send Inquiry